The TurboVNC Viewer assumes that, if the "Via" parameter does not contain a display number/port, then it should connect to an SSH server rather than an UltraVNC Repeater. VNCViewer supports numerous command line parameters which allow for configuration of nearly every aspect of the viewer. Parameters can be turned on with -param or off with -param0.Parameters which take a value can be specified as -param value. The only difference is that, with SSH tunneling, a display number/port is not specified for the gateway machine. PARAMETERS VNC parameters can be set both via the command-line and through the vncconfig(1) program, and with a VNC-enabled Xorg server via Options entries in the nf file. Run vncpasswd with one of the following flags to specify a password of at least six case-sensitive alphanumeric characters for a particular VNC Server mode and user.The password chosen is encoded and stored as the value of the Password parameter in the specified configuration file:-service VNC Server in Service Mode. This is, incidentally, very similar to the procedure for SSH tunneling with the TurboVNC Viewer, which is documented in the User's Guide. example vncviewer listen non standard port 80 vncviewer.exe -listen 80 -dsmplugin filename.dsm example1: vncviewer.exe host -dsmplugin msrc4plugin.dsm example2: vncviewer.exe host. If port is specified, the viewer listens on that port instead of 5900 default port. listen port Start the VNCviewer in listen mode. The "Via" parameter specifies the gateway hostname/IP address + repeater display number/port, and the "Server" parameter specifies the VNC server hostname/IP address + display number/port (from the gateway's point of view.) UltraVNC Viewer Commandline Parameters -help, - or -h Print a help message. This configuration contains the following: connection hostmyvncserver port5901 passwordencryptedpassword options restricted0 viewonly0 fullscreen0. DirC:\Program Files\uvnc bvba\UltraVNC GroupUltraVNC NoIcons1 SetupTypecustom Componentsultravncserver,ultravncviewer Tasksinstallservice,startservice, When the command line runs it's failing to install the service and start the service for server which is what I need it to do. Using a configuration file works fine: vncviewer.exe /config config.vnc. Then make a little batch file containing the following: ftype UltraVnc. You can also do this entirely using Java parameters, which can be passed on the command line or with Java Web Start. I would like to launch vncviewer in a script on Windows. command line You can launch a RealVNC Viewer connection at the command line. Thus, if the TurboVNC Server session is running on the same machine as the UltraVNC Repeater, then the VNC server hostname would be "localhost". NOTE: the hostname/IP address of the VNC server machine should be specified from the point of view of the gateway/repeater machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |